MICROWELL DRY 500 Installation Manual download pdf (Page 3)

3.1.

INSTRUCTIONS FOR USE

Humidity regulation with an inbuilt digital humidistat located in the cover of the equipment

WALL-MOUNTED SWIMMING POOL DEHUMIDIFIER - OWNER´S & INSTALLATION MANUAL

The inbuilt humidistat is located in the cover of the device. It reads the humidiy of the incoming air, and depending on the set value,

switches on the compressor. In indoor swimming pool halls, the optimal air humidity level should range between 55% and 65 %.

Decreasing the level of humidity under the above mentioned range is not desirable, considerating the physiological aspects as well

as the aspects of providing building protection. Moreover, it increases the consumption of electrical energy. The humidistat can be

controlled by the user.

Humidistat display (front view)

Luminous point

signals, that the

humidity is shown on

display.

Luminous point indicates that

the regulator gives signal to

dehumidify, i.e. requested

humidity is lower than actual.

Luminous point indicates

that the regulator gives

signal to heat the air. This is

applicable if LPHW and

Solenoid valve are installed.

Not illuminated point

indicates that the requested

air temperature is lower than

actual.

Luminous point signals,

that the temperature is

shown on display.

Failure reporting

Memory failure. Switch off and then switch on again the electrical connection.

If the failure reporting continues, please ask us to change the component.

Sensor failure. The electrical connection of the sensor is broken off.

Please control the cable.

Sensor failure. The sensor is short-circuited. Please control the cable.

Er1

0-E

S-E

1 2 3 4 5 6 7 8 ... 19 20

No comments

MICROWELL DRY 500 Installation Manual Page 3